Amazing tough high build epoxy coating for walls and floors. Silk Gloss. Can be used on any surface including damp concrete to get a tough coloured hard wearing finish.
Any colour from the RAL colour matching system you like at no extra cost within 24 hours. Water based and very very easy to use.
Just state the colour you require when ordering, and we will tint the product to your choice. Use this product for all locations where you require a hard wearing dust free coating. It can be used to paint over screeds, concrete, timber, plasterboard, bitumen, tarmac, most other paints.
- Very Fast drying
- No primer needed
- Clean tools with water
- Silk finish
- Solvent free
- Very easy to apply
- Good chemical resistance
- Slip resistant additive available
- Clean up the floor, remove dust, oil or grease which may reduce the bond.
- Open the base and hardener components using pliers.
- Thoroughly mix the two together.
- Apply by short pile roller to the floor.
- Clean tools with water.
Normally 2 coats is advised for the best finish. Allow to dry between coats.
0 comments:
Post a Comment